Need help with SSH's Description Module

Gribbler · Mon 29/04/2013 14:35:23

Hi all!

Could anyone who used SSH's description module help me with it? I must admit, reading moudle codes is like reading Chinese to me

Here's my problem.

[IMGzoom]http://i.imgur.com/lXRB2HH.png[/IMGzoom]
[IMGzoom]http://i.imgur.com/ERh7vP3.png[/IMGzoom]

As you can see some letters are "cut off" at the top (black outline is missing) and I can't quite figure out why. As if there was some border. What parameters in Description Module should I change? I tried a few and nothing works so far.

Khris · Mon 29/04/2013 14:53:32

Like was explained in the other thread, this is simply an issue of a label being positioned too far up on the GUI.
Since modules can't create GUIs, I assume you were told to put a label on a GUI yourself. Just open the GUI in the editor, select the label by clicking it, then add 1 or 2 to it's "Top" value in the properties.

SSH · Mon 29/04/2013 15:02:37

Quote from: Gribbler on Mon 29/04/2013 14:35:23
I must admit, reading moudle codes is like reading Chinese to me

Wo shuo yi dianr hanyu!

Also, Khris's answers sounds about right: you have to size the GUIs and controls manually!

Gribbler · Mon 29/04/2013 15:04:17

Aaaaand the magic happened.

Thanks guys for translating Chinese for me!

Ghost · Mon 29/04/2013 17:03:08

I was speaking Chinese and I didn't even notice!

Gilbert · Mon 29/04/2013 17:15:12

To be honest, I am Chinese and I speak Chinese too, but I don't recognise a single word here.

Gribbler · Mon 29/04/2013 17:48:10

It must be Sumerian then. Sorry guys, my bad!

Stupot · Tue 30/04/2013 00:08:06

It's all Greek to me :/

Tramponline · Tue 30/04/2013 09:30:13

Poppycock! It's nerdological Babylonian mumbo-jumbo, sprinkled with Esperanto for good measure. Blade Runner speak!