Hi all!
Could anyone who used SSH's description module help me with it? I must admit, reading moudle codes is like reading Chinese to me :sad:
Here's my problem.
[IMGzoom]http://i.imgur.com/lXRB2HH.png[/IMGzoom]
[IMGzoom]http://i.imgur.com/ERh7vP3.png[/IMGzoom]
As you can see some letters are "cut off" at the top (black outline is missing) and I can't quite figure out why. As if there was some border. What parameters in Description Module should I change? I tried a few and nothing works so far.
Like was explained in the other thread, this is simply an issue of a label being positioned too far up on the GUI.
Since modules can't create GUIs, I assume you were told to put a label on a GUI yourself. Just open the GUI in the editor, select the label by clicking it, then add 1 or 2 to it's "Top" value in the properties.
Quote from: Gribbler on Mon 29/04/2013 14:35:23
I must admit, reading moudle codes is like reading Chinese to me :sad:
Wo shuo yi dianr hanyu!
Also, Khris's answers sounds about right: you have to size the GUIs and controls manually!
Aaaaand the magic happened.
Thanks guys for translating Chinese for me! (laugh)
I was speaking Chinese and I didn't even notice!
To be honest, I am Chinese and I speak Chinese too, but I don't recognise a single word here.
It must be Sumerian then. Sorry guys, my bad! :smiley:
It's all Greek to me :/
Poppycock! It's nerdological Babylonian mumbo-jumbo, sprinkled with Esperanto for good measure. Blade Runner speak! :tongue: