Adventure Game Studio

AGS Support => Advanced Technical Forum => Topic started by: 00jon00 on Wed 10/03/2004 23:22:29

Title: Read error
Post by: 00jon00 on Wed 10/03/2004 23:22:29
When I try to load room 6 so I can edit it, it gives me an error message:
---------------------------
AGS Editor
---------------------------
Read error decompressing image - file is corrupt
---------------------------
OK  
---------------------------
When you click 'ok', it kicks you out of AGS.  If you just test the game then it brings up this error when (and only) in room 6:
---------------------------
Adventure Game Studio
---------------------------
An internal error has occured. Please note down the following information.
If the problem persists, contact Chris Jones.
(ACI version 2.60.693)

Error: Out of memory: failed to allocate -56112 bytes (at PP=200)

---------------------------
OK  
---------------------------
It was working just fine a little while ago, but then I re-booted my pc and its started this...Does anybody know whats going on? (I'm not much of a computer wiz...Sorry)
Title: Re:Read error
Post by: Gilbert on Thu 11/03/2004 01:45:04
Quite possibly your room file is currupted, try to find a backup for it or rework on it.
Title: Re:Read error
Post by: 00jon00 on Thu 11/03/2004 02:47:10
Thanks Gilbot V7000a...I'm just going to restart my game lol...I was all ready looking for an excuse to.
8)
Title: Re:Read error
Post by: Pumaman on Thu 11/03/2004 21:17:02
When you restarted your computer, was it a normal Windows restart, or did you physically press the reset button? Often writes to disk are delayed and so it may not have finished saving the file before restarting.
Title: Re:Read error
Post by: 00jon00 on Thu 11/03/2004 22:55:57
It was a regular re-boot...
Title: Re:Read error
Post by: Pumaman on Fri 12/03/2004 16:20:19
Well, it looks like the room 6 room file didn't save properly, at any rate. It's possible you ran out of disk space, further than that I'm not sure what to suggest other than to restore a backup.
Title: Re:Read error
Post by: 00jon00 on Sat 13/03/2004 03:35:50
Thanks...I restored the system to the previous day and it has worked since...Thanks guys